11/15/2023 0 Comments Oxygen not included steam powerThere's a few hundred kg/tile of Petroleum on the floor to help balance and transfer the heat around. Insulated tiles and pipes are Ceramic Drywall is Granite Tempshift plates are diamond. The AquaTuner only needs to be made of Steel and not Thermium, since it is kept is a separate chamber that runs cooler than the main steam chamber. This design is doing a pretty fair job of running at the right temperatures, but is wasting a bit of the thermal energy. Ideal temp for a turbine with all 5 ports open is 200 C, and the ideal temp for a turbine with 4 ports open is 226 C. The main steam chamber temperatures range between 195 C just before a new eruption starts to a peak of about 250 C. It opens the Liquid Vents and disables the Liquid Shutoff to divert water back to the main steam chamber when the steam pressure drops below what is needed to keep the turbines running at full power. The Atmo Pressure Sensor is set to around 2.5 kg. This turns off the Steam Turbines if the steam is not hot enough for the turbines to run at peak power. Inside the main steam chamber, the Thermo sensor is set to 190 C. This vent is active enough for it to be up around 190 C, but less active vents the AquaTuner chamber is usually more like 160 C. There's a pressure sensor set to 20kg, which opens the Liquid Vent and adds more water to the AquaTuner chamber as needed. The AquaTuner is cooling a loop of Brine to 30C, controlled by the Pipe Thermo Sensor. The map seed is S-FRZ-1726386072-0, which has a high-output vent down and to the right of the printing pod, which produces 1.83 kg/s of steam. Here is a split-steam design for a Steam Vent tamer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |